Hopefully someone has a suggestion here, because I am out of ideas. I have a N2024 switch, which I have enabled ip routing on. I have two VLANS, the default VLAN1, and a management VLAN99.

VLAN 1 10.10.1.0/24 OOB

VLAN 99 10.10.99.0/24 MGMT

The switch has an IP enabled for both VLANs, x.x.x.254.

I have two ACLs set, one for each inbound vlan, with the same name. The following ACEs are in each:

OOB ACL (Linked to inbound vlan 1):

1000 permit ip 10.10.1.0 0.0.0.255 10.10.1.0 0.0.0.255

2000 permit ip 10.10.1.0 0.0.0.255 10.10.99.0 0.0.0.255

MGMT ACL (Linked to inbound vlan 99):

1000 permit ip 10.10.99.0 0.0.0.255 10.10.99.0 0.0.0.255

2000 permit ip 10.10.99.0 0.0.0.255 10.10.1.0 0.0.0.255

 

From my understanding, this should allow for IP traffic to travel between the vlans. In testing, however, the following happens:

I can successfully ping from vlan99 to vlan1

I can successfully ping from vlan1 to vlan99

I successfully pull up a webpage hosted on vlan 1 from a different host on vlan 1

I FAIL to pull up a webpage hosted on vlan 1 from a different host on vlan 99

I successfully pull up a webpage hosted on vlan 99 from a different host on vlan 99

I FAIL to pull up a webpage hosted on vlan 99 from a different host on vlan 1

Basically, While I can ping between the vlans, no other traffic seems to complete. What am I missing? All IPs are manual.

Running show ip route gives me:

No default gateway is configured

C *10.10.1.0/24 [0/0] Directly connected, Vl11

C *10.10.99.0/24 [0/0] directly connected, Vl99

To Summarize, with IP ACLs connected to each vlan (inbound) i can only ping across the vlans, but no actual traffic can pass other than pings. What have I missed?