-=<###>=-
Instantiating /ram as rawFs,  device = 0x1
Formatting /ram for DOSFS
Instantiating /ram as rawFs, device = 0x1
Formatting...Retrieved old volume params with %38 confidence:
Volume Parameters: FAT type: FAT32, sectors per cluster 0
  0 FAT copies, 0 clusters, 0 sectors per FAT
  Sectors reserved 0, hidden 0, FAT sectors 0
  Root dir entries 0, sysId (null)  , serial number 10000
  Label:"           " ...
Disk with 1024 sectors of 512 bytes will be formatted with:
Volume Parameters: FAT type: FAT12, sectors per cluster 1
  2 FAT copies, 1010 clusters, 3 sectors per FAT
  Sectors reserved 1, hidden 0, FAT sectors 6
  Root dir entries 112, sysId VXDOS12 , serial number 10000
  Label:"           " ...

RTC Error:  Real-time clock device is not working
OK.

Adding 13818 symbols for standalone.

 

Reset, Power-Up Diagnostics - Loop 1 of 1
3600 Processor DRAM
     01 Data lines                                                  Passed
     02 Address lines                                               Passed
3300 NVSRAM
     01 Data lines                                                  Passed
4410 Ethernet 82574 1
     01 Register read                                               Passed
     02 Register address lines                                      Passed
6D40 Bobcat
     02 Flash Test                                                  Passed
3700 PLB SRAM
     01 Data lines                                                  Passed
     02 Address lines                                               Passed
6D50 LSISAS2008 IOC 1
     01 Register Read Test                                          Passed
     02 Register Address Lines Test                                 Passed
     03 Register Data Lines Test                                    Passed
3900 Real-Time Clock
     01 RT Clock Tick                                               Passed
Diagnostic Manager exited normally.
07/28/18-23:42:52 (tNetCfgInit): NOTE:  Network Ready
07/28/18-23:42:55 (tNetTask): NOTE:  eth0: LinkUp event

Current date: 07/29/18  time: 06:20:41

Send for Service Interface or baud rate change
07/28/18-23:43:08 (tRAID): NOTE:  Set Powerup State
07/28/18-23:43:09 (tRAID): SOD Sequence is Normal, 0 on controller A
07/28/18-23:43:09 (tRAID): NOTE:  Turning on tray summary fault LED
07/28/18-23:43:09 (tRAID): NOTE:  Installed Protocols:
07/28/18-23:43:09 (tRAID): NOTE:  Required  Protocols:

 

Any ideas as to what I may be doing wrong?

James