When you replace a EQL CM you swap your old SD/Flash card which holds the right FW into the new CM. Otherwise you have unmatched FWs in the EQL.

Regards
Joerg

Don - how would you select the control module to target the update? I am in the same situation and show one of the modules in an older version.

Hello, 

 If you are trying to transfer a KIT to the active CM and THEN run update, that will never work. 

 The only thing you can try is go to the CLI of the active CM.  Make sure there is NO firmware kit installed. 

A sample on how to check for kit files and remove them.  The FILENAME will begin with kit and end in .tgz 

GrpName> su exec "ls -l"
You are running a support command, which is normally restricted to PS Series Tec
hnical Support personnel. Do not use a support command without instruction from
Technical Support.
total 12
-rw------- 1 root wheel 35 May 17 2022 .lesshst
-rwxr-x--x 1 grpadmin wheel 1083 Nov 18 2020 rm_badchap.sh
-rw-r--r-- 1 root wheel 0 Jul 22 14:05 example.txt
drwxrwxrwx 2 root wheel 512 Nov 11 2020 usr
GrpName> su exec "rm example.txt"
You are running a support command, which is normally restricted to PS Series Tec
hnical Support personnel. Do not use a support command without instruction from
Technical Support.
GrpName> su exec "ls -l"
You are running a support command, which is normally restricted to PS Series Tec
hnical Support personnel. Do not use a support command without instruction from
Technical Support.
total 12
-rw------- 1 root wheel 35 May 17 2022 .lesshst
-rwxr-x--x 1 grpadmin wheel 1083 Nov 18 2020 rm_badchap.sh
drwxrwxrwx 2 root wheel 512 Nov 11 2020 usr

Once you have verified that no upgrade kits are installed.  run 'update' at the CLI. 

GrpName>update

 Follow any prompts and this should sync the passive CM to the active one. 

 Then reboot the passive CM so it will sync with the primary again. 

  Regards, 

Don