Learn how to replace the M.2 2230 solid-state drive on Inspiron 16 Plus 7640. This video shows how to remove and install the M.2 2230 solid-state drive on Inspiron 16 Plus 7640. Before you begin, power off the computer, and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system. If you need more information or assistance, go to: Dell.com/Support.
This video shows how to replace the M.2 2230 solid-state drive or SSD on an Inspiron 16 Plus 7640. Before you begin, ensure that you always use ESD protection when working inside the computer. Disconnect all the attached peripherals and enter service mode. To enter Service Mode, press and hold the B key on the keyboard, and then press the power button. Now, the computer will boot up and the Owner Tag information is displayed on screen. Press any key to proceed. The computer will emit three short beeps and shut down.
Now to begin, loosen the two captive screws and then remove the six screws that secure the base cover to the palm-rest and keyboard assembly. Using a plastic scribe, pry the base cover from the top left at the hinge, and then continue to work on the sides to open the base cover. Slide and lift the base cover off the palm-rest and keyboard assembly. Remove the screw that secures the M.2 2230 assembly in place. With the assembly at an angle and slide it from the slot on system board. Turn and place it on a dry and flat surface. Remove the screw that secures the SSD to the thermal shield. Then, remove the drive from the shield.
Now, let’s install the M.2 2230 solid-state drive. Align the screw hole on the M.2 2230 solid-state drive with the screw hole on the M.2 thermal shield. And replace the screw that secures the shield to the drive. Locate the notch on the solid-state drive. And, align the notch with the tab on the SSD slot. Then, slide the assembly into the slot on the system board. Replace the screw that secures the M.2 thermal shield to the system board.
Now, let's install the base cover. Place and snap the base cover on the palm-rest and keyboard assembly. Tighten the two captive screws and then replace the six screws that secure the base cover to the palm-rest and keyboard assembly. With the computer assembled, connect the power adapter. Press the power button and power on the computer to exit from Service Mode. Please note, the computer will only turn on if the power adapter is connected. If you need more information or assistance, go to: Dell.com/Support.
