LSI 9210 SAS RAID CARD 3G LED firmware

1.When ios are running with cable break and make (b/w expander and drive),fault 8405 is hit
2.One of the inactive volumes member becomes offline/missing
3.0xC00C fault observed while doing Target Mode Aborts while running IOs
4.Incorrect data length reported for failed target mode transfers
5.RAID1 Volume fails to start resync when a hot plugged hot spare is available
6.On exiting PCIe Power management state, some configuration bits are not reset
7.Request Sense Command is showing incorrect data during Send Diagnostic foreground mode Command is issued.
8.pl: SATL: Sense data Valid bit and Information field may not be populated correctly
9.SAS2 IT - Phase 14 ?Allocation Length for SCSI MODE SENSE Command is not Handled Properly
10.SAS2 IT : Phase 14 : Cannot abort a background short Self test
11.Truncated Data is Obtained When SCSI Inquiry to VPD Page 0xB0 is Executed
12.Extra 60 Bytes of VPD Page Data is Provided When SCSI Inquiry to VPD Page 0x89 is Executed
13.SATL translation happens in firmware for a Persistent Reservation Command with SA=3 for a Invalid PLL
14.pl: SATL: Translation for foreground SELF TEST CODE field in Self Test Results log is incorrect
15. IT - Phase 14 ?When SATA Drive is Moved to Standby State via Mode Page(0x1a), ASC/ASCQ is Incorrect for REQUEST SENSE
16.SAS2 IT - Phase 14 ?Allocation Length for SCSI READ CAPACITY(16) Command is not Handled Properly
17.ManPage11 NVTime variable needs to be increased for all 2308 B0 and D1 HBAs with MRAM
18. PI error reported when PI error detected due to a frame CRC error
19. 4101 fault on link break during frame transmission
20.RAID1 volume fails to resync when compatible drive is available
21. DwsResetDef is unexpectedly modified to maximum value if Linear mode is utilized
22.Raid Accelerator IOs hang with injected Guard Errors or when running Multi-threaded IOs
23.Dell DCS request to make a new point release (based off the latest point release) to include 3G-lock and LED mapping fix