如何在 VPLEX 上啟用自動復原

Summary: 如何在 VPLEX 上啟用自動復原。如何將屬性設為 True。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

目標

在 VPLEX

Facts

VPLEX

解決方案

上開啟 Auto resume，您可以在兩處 （直接在分散式裝置或一致性群組上） 啟用。

對於分散式磁片區，只需移至 DD 並執行命令：
  
VPlexcli:/  cd /distributed-storage/distributed-devices/
VPlexcli:/distributed-storage/distributed-devices cd dd_test0
VPlexcli:/distributed-storage/distributed-devices/dd_test0 set auto-resume true

VPlexcli:/distributed-storage/distributed-devices/dd_test0

Name Status Operational Health Auto Rule Set Name Transfer
---------------------------------- ------- Status State Resume ------------------ Size
---------------------------------- ------- ----------- ------ ------ ------------------ --------
dd_test0 running ok ok true cluster-1-detaches 2M
 
您會注意到「Auto Resume」欄已變更為 True，確認在還原連線後，裝置將會自動重新開機。

若為一致性群組，則為相同原則，但位置不同：
  
VPlexcli:/ cd /clusters/cluster-1/consistency-groups/
VPlexcli:/clusters/cluster-1/consistency-groups cd cg_dd_tst
VPlexcli:/clusters/cluster-1/consistency-groups/cg_dd_tst cd advanced/
VPlexcli:/clusters/cluster-1/consistency-groups/cg_dd_tst/advanced set auto-resume-at-loser true
VPlexcli:/clusters/cluster-1/consistency-groups/cg_dd_tst/advanced
 

一旦定義完畢，此設定將適用于一致性群組中的所有分散式裝置。

Affected Products

VPLEX
Article Properties
Article Number: 000205427
Article Type: How To
Last Modified: 16 Nov 2022
Version:  1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.