Difference Between AHCI and SATA

Different standards

IDE - Integrated Drive Electronics (1^st version of ATA)

ATA - Advanced Technology Attachment

PATA – Parallel ATA

SATA - Serial ATA

AHCI - Advanced Host Controller Interface

SATA is a Serial ATA interface that is meant to replace the aging PATA technology. It provides a lot of advantages compared to PATA, including faster data speeds. The Advanced Host Controller Interface or commonly known as AHCI is a new programming standard that defines a new mode of operation for SATA that adds two extra features; NCQ and hot-plugging.

NCQ stands for Native Command Queuing, a feature that modifies the sequence in which data is retrieved. Instead of servicing each request sequentially like in traditional systems, it analyzes all the requests and plots out a path that takes the least amount of time to service all requests. The result of this is somewhat uneven as although the total time is reduced, some of the earlier requests might be sent to the back of the list. Hot-plugging is a feature that doesn’t really improve the performance of the system but makes it easier and more convenient for users to add or replace disks. Hot-plugging simply allows users to remove or connect drives without needing to turn the whole system off; pretty much like a flash drive.

In order to maximize the compatibility of SATA to hardware that is being manufactured, manufacturers introduced a couple of modes of operation including AHCI and Legacy IDE. Legacy IDE aimed to provide compatibility with older devices while foregoing the advanced functionalities that are available when using AHCI. Depending on the hardware that you have and its relative age, you might have a SATA controller that does not support AHCI, thereby reducing your choices.

AHCI is a little bit more complicated to implement compared to your other choices with SATA as it requires special drivers that needs to be installed. Even when switching to AHCI from an older installation that did not use AHCI can lead to problems as it is quite common for the motherboard to not recognize the drive and not boot your operating as it should. There are steps that can be taken in order to make the transition a bit easier, though updating your hardware and operating system often solves the problem.

Summary:

1. SATA is a relatively new interface standard commonly used for storage media while AHCI is a programming interface that adds extra functionalities

2. AHCI introduces NCQ and hot-plugging capabilities

3. SATA can operate on IDE or AHCI

4. Certain hardware can support SATA without AHCI

5. AHCI is a bit more complicated to implement