PowerEdge: ESXI에서 VMNic 업링크 추가 및 제거
Summary: VSS(Standard Switch) 및 VDS(Distributed Switch)에 VMNICS 추가 및 제거
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Instructions
- 현재 보기
vSwitchconfiguration 및vmkernel다음 명령을 사용한 인터페이스 구성:esxcli network vswitch standard list # list current vswitch configuration esxcli network vswitch dvs vmware list # list Distributed Switch configuration esxcli network ip interface list # list vmkernel interfaces and their configuration esxcli network nic list # display listing of physical adapters and their link state
- 다음 명령을 사용하여 표준 vSwitch에 네트워크 카드(vmnics라고 함)를 추가하거나 제거합니다.
esxcli network vswitch standard uplink remove --uplink-name=vmnic --vswitch-name=vSwitch # unlink an uplink esxcli network vswitch standard uplink add --uplink-name=vmnic --vswitch-name=vSwitch # add an uplink
- 다음 명령을 사용하여 vDS(vNetwork Distributed Switch)에서 네트워크 카드(vmnics라고 함)를 추가하거나 제거합니다.
esxcfg-vswitch -Q vmnic -V dvPort_ID_of_vmnic dvSwitch # unlink/remove a vDS uplink esxcfg-vswitch -P vmnic -V unused_dvPort_ID dvSwitch # add a vDS uplink참고: 관리 네트워킹을 분산 스위치로 마이그레이션할 때 연결이 끊어지면 기존 관리 VMkernel 인터페이스를 제거하거나 비활성화하고 동일한 IP 구성으로 표준 vSwitch 포트 그룹에 다시 생성해야 할 수 있습니다.
예:-
Vmnci4를
다음을 확인합니다.
업링크에서 VMNIC 제거


0 추가
업링크 포트를 추가하기 전에 DVS 이름 및
VMNIC가 다음에 추가되는지 확인
제거
Vmnci4를
vSwitch (표준)
다음을 확인합니다.
vswitch 이제 vmnic 4 은(는) 업링크에 추가됩니다.
업링크에서 VMNIC 제거
vSwitch 
0 추가
VMNIC4 VDS(분산 스위치)에 대한 업링크, 업링크 포트를 추가하기 전에 DVS 이름 및
DVPort ID는 사용 가능한 포트여야 합니다. 이 예에서 포트 번호 11은 사용되지 않았습니다.
VMNIC가 다음에 추가되는지 확인
DVS 업링크.
제거
VMNIC 다음에서 업링크 VDS,
Affected Products
VMware ESXi 6.7.X, VMware ESXi 6.x, VMware ESXi 7.xArticle Properties
Article Number: 000198710
Article Type: How To
Last Modified: 02 Apr 2025
Version: 2
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.