Please select a product to check article relevancy
This article applies to This article does not apply toThis article is not tied to any specific product.Not all product versions are identified in this article.
但是,如果磁盘组中的硬盘已更换为更大的磁盘,可用空间将显示在以下位置: WithArrExp 在”PERCCLI /cx/vx show expansion.“
图 6:PERCCLI 输出 WithArrExp
Cause
PERC HII 配置实用程序和 iDRAC 不支持扩展阵列容量。
Resolution
使用 Dell 扩展阵列容量 PERCCLI 效用:
1. Run "perccli /cx/vx show expansion" to determine the available expansion space.
2. Then run "perccli /cx/vx expand Size=<xx> expandarray" to perform the array expansion.
The expand command will expand the virtual drive within the existing array if there is available space, or expand into additional capacity if the drives have been replaced with larger ones.
The <xx> size value is specified in GB.
If the "expandarray" option is specified, the full array capacity will be expanded.
If this option is not specified, only the virtual drive capacity will be expanded rather than the full array.