VxBlock: Cisco-problem CSCwh11744 – ACLTCAM-servicerapporter switch om nedbrud og genindlæsning

Summary: Cisco-problem CSCwh11744 – ACLTCAM-tjenesten rapporterer et nedbrud og indlæser switchen igen.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Symptoms

Switch med N-Port Identifier Virtualization (NPIV)-funktionen aktiveret genindlæser med ACLTCAM-nedbrud under oprettelse af UP-portkanal forbundet med N-Port Virtualizer (NPV)-switch. 
show system reset-reason

----- reset reason for module 1 (from Supervisor in slot 1) ---
1) At 439618 usecs after Tue Aug 8 12:38:22 2023
Reason: Reset triggered due to HA policy of Reset
Service: acltcam hap reset
Version: 8.4(2e)

Cause

Kendt problem i 8.4(2e)-firmware

Resolution

Løsning:
Bring hvert medlem af portkanalen op en efter en.

Additional Information

Se Cisco CSCwh11744: Værktøj til søgning efter problemer (cisco.com) (eksternt link) 

Affected Products

VxBlock System 1000
Article Properties
Article Number: 000221106
Article Type: Solution
Last Modified: 30 Dec 2025
Version:  2
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.