Dell Unity: How to change the SNMP port from default port 162 to a specified port on Unity (Customer Correctable)

Summary: The SNMP default UDP port number is 162. If the customer configures a specified port to receive SNMP trace on SNMP manager, the following steps can be followed to specify the SNMP port. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

1. In the Unisiphere GUI Select Settings-->Alerts-->SNMP to configure the SNMP trap destination Target.
2. On the Manage SNMP alerts page, click the Add (+) button and enter the network IP & port on the SNMP target window then select OK.
screen shot of SNMP settings 

3. Click Send Test SNMP Trap to verify the SNMP configuration and click OK.
screen shot of manage SNMP alerts for sending SNMP test 

 



 

Additional Information

TCPDUMP was collected on the mgmt port to verify if the SNMP trap sent out to the SNMP server
The SNMP server that is configured must listen on the port specified here to make sure it receives the trap
 

Affected Products

Dell EMC Unity
Article Properties
Article Number: 000227734
Article Type: How To
Last Modified: 14 Nov 2024
Version:  2
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.