PowerStore: How to connect to the service console over SSH

摘要: Instructions to connect to the service console (service container) on PowerStoreT and PowerStoreX

本文适用于 本文不适用于 本文并非针对某种特定的产品。 本文并非包含所有产品版本。
查看其他资源

症状

PowerStore T and PowerStore X models use different physical ports for the management network access.

  • PowerStore T uses port labelled 6.
  • PowerStore X uses ports 0-1 (or bond) on the module labelled 1.

For ssh access using the service port instead of the management port, see PowerStore: SSH and PowerStore Manager access using the Service LAN Ports.
Note: When connecting to the service port, do not disconnect the management cables.


The ssh port used to log in to the service container is:

  • 22 - After the cluster creation is completed.
  • 26 - Before the Initial Configuration Wizard (ICW) is run.

原因

SSH access to the nodes may be required for troubleshooting.

解决方案

SSH is not enabled for PowerStore appliances by default. To enable SSH access to the appliance:

  1. Go to Settings.
  2. Select SSH Management from the Security section.
  3. Select the appliance or appliances on which to enable SSH.
  4. Click ENABLE SSH. To disable SSH access, follow the same procedure, but click DISABLE SSH.


Only the user service can log in over ssh. The error below is observed if the wrong username is entered: 
No supported authentication methods available (server sent: publickey,gssapi-keyex,gssapi-with-mic)


Example:
image.png
 


The service user password is the password that you have setup during the Initial Configuration Wizard (ICW). The service password can be reset from the PowerStore Manger user interface, under Settings > Support > Service Account.

受影响的产品

PowerStore
文章属性
文章编号: 000131579
文章类型: Solution
上次修改时间: 19 12月 2022
版本:  6
从其他戴尔用户那里查找问题的答案
支持服务
检查您的设备是否在支持服务涵盖的范围内。