TL1000 : How to find the service Tag via the Java Web Interface?
摘要: This tutorial explains how to find the PowerVault TL1000 Service Tag via the management web interface.
本文章適用於
本文章不適用於
本文無關於任何特定產品。
本文未識別所有產品版本。
症狀
Note: This article is part of the Dell PowerVault knowledge library, available 原因
-
解析度
This tutorial explains how to find the PowerVault TL1000 Service Tag via the management web interface. It works only for library where the firmware is in version 0071.3000 or later. If the service tag is not displayed, the solution is to physically check in front of the device.
The library management interface IP address has to be reachable.
Java has to be installed on your server.
Open an internet navigator and connect to the library mangement inteface.
You will receive a default Java welcome message:
Check "I accept the risk and want to run this application" , then click on Run
Connect with the administrator credentials, the default password is:
On the home page you will find the Service Tag on the right of "Service Tag". The library serial number is not the Service Tag.
Warning: The Service Tag will be displayed only when Library Firmware is in version 0071.3000 or later. The library serial number is not the Service Tag.
Prerequisites:
The library management interface IP address has to be reachable.
Java has to be installed on your server.
Steps:
Open an internet navigator and connect to the library mangement inteface.
You will receive a default Java welcome message:
Check "I accept the risk and want to run this application" , then click on Run
Connect with the administrator credentials, the default password is:
| Account | admin |
| Password | secure |
On the home page you will find the Service Tag on the right of "Service Tag". The library serial number is not the Service Tag.
受影響的產品
PowerVault TL1000文章屬性
文章編號: 000140793
文章類型: Solution
上次修改時間: 07 10月 2021
版本: 5
向其他 Dell 使用者尋求您問題的答案
支援服務
檢查您的裝置是否在支援服務的涵蓋範圍內。