Zu den Hauptinhalten
  • Bestellungen schnell und einfach aufgeben
  • Bestellungen anzeigen und den Versandstatus verfolgen
  • Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
  • Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.

Inspiron 7586 Service Manual

Procedure

  1. Place the display panel on a clean and flat surface.Image: Display panel
  2. Replace the display cable.
  3. Replace the camera.
  4. Remove the release paper from the SR tapes.Image: Removing the release paper from the SR tape
  5. Align both the SR tapes to the plastic edge of the display back-cover and antenna assembly and paste them.
  6. Remove the blue release paper of SR tape.Image: Removing the release paper from the SR tape
  7. Slide the top of display panel into the display back-cover and antenna assembly and place the display panel onto the display back-cover and antenna assembly. Image: Replacing the display panel
  8. Replace the two screws (M2x3) that secure the display panel to the display back-cover and antenna assembly.
  9. Route the display cable and the touchscreen-board cable through the routing guides on the display hinge.
  10. Place the display bezel on the display back-cover and antenna assembly and snap it into place.Image: Replacing the display bezel
  11. Remove the release paper from the pressure film.Image: Removing the release paper from the pressure film
  12. Adhere the pressure film on the display panel.
  13. Using the flat end of the plastic scribe, press the pressure film until it turns red.
  14. Peel off the pressure film from the display panel. Image: Peeling off the pressure film

Diesen Inhalt bewerten

Präzise
Nützlich
Leicht verständlich
War dieser Artikel hilfreich?
0/3000 characters
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie an, ob der Artikel hilfreich war.
  Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\