Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

Configured LSA timers replace the standard transmit and acceptance times for LSAs.

1. Specify the interval times for all LSA transmissions. CONFIG-ROUTEROSPF- id mode timers throttle lsa all {start-interval | hold-interval | max-interval}
   • start-interval: set the minimum interval between the initial sending and resending the same LSA. The range is from 0 to 600,000 milliseconds.
   • hold-interval: set the next interval to send the same LSA. This interval is the time between sending the same LSA after the start-interval has been attempted. The range is from 1 to 600,000 milliseconds.
   • max-interval: set the maximum amount of time the system waits before sending the LSA. The range is from 1 to 600,000 milliseconds.
2. Specify the interval for LSA acceptance. CONFIG-ROUTEROSPF- id mode timers throttle lsa arrival arrival-time
   • arrival-time : set the interval between receiving the same LSA repeatedly, to allow sufficient time for the system to accept the LSA. The range is from 0 to 600,000 milliseconds.