Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Your Dell.com Baskets

Dell Edge Gateway5000 Series Installation and Operation Manual

PDF

Installing the PCIe card into the IO module

  • CAUTION: Electrical and electronic devices are sensitive to electrostatic discharge (ESD). Exposure to ESD can harm your device and potentially cause it not to function properly. Ensure that you are properly grounded before handling the mobile broadband card.
  • NOTE: Install the PCIe expansion card in the IO expansion module before mounting it on a wall mount or DIN rail.
  1. Open the IO module.
    1. Remove the dust caps and loosen the access cover screw that secures the IO expansion module to the cover.
    2. Slide the module in the direction shown, and then carefully lift the top cover from the module.
    • CAUTION: Remove the cover carefully to avoid damaging the LED light cable, which is mounted on the bottom of the cover.
    Image: Loosening the access cover screw
  2. Remove the PCIe expansion card-slot cover.
    Image: Removing the PCIe expansion card-slot cover
  3. Install the PCIe card into the PCIe expansion card slot on the IO expansion module and secure with a screw.
    Image: Installing the PCIe card
  4. Replace the cover on the IO expansion module.
    Image: Replace the cover
  5. Tighten the screw that secures the cover to the IO expansion module.
    Image: Replace the cover screw
    • NOTE: Replace the dust caps on any unused ports and connectors.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\