Manually import and install OMIMSSC configuration management pack on SCOM
To enroll management servers to OMIMSSC, you must first import and install the configuration management pack on the SCOM console by doing the following:
In the left pane, click
Administration > Management Packs > Installed Management Packs.
A list of all the management packs installed on SCOM is displayed.
To run the task of importing OMIMSSC management packs, in the
Tasks pane, click
Import Management Packs.
The
Import Management Packs wizard is displayed.
From the
Add list, select
Add from disk.
If prompted to search the online catalog for missing management packs, click appropriately.
Double-click the downloaded management pack file.
Select the
Dell.EMC.OMIMSSC.Configuration.mp file, and then click
Install.
The selected management pack file is imported (downloaded) and deployed on SCOM. After you download and import the configuration management packs to the SCOM console, you can enroll management servers to the OMIMSSC appliance. The management packs perform the following actions on the management server where SCOM is configured:
Enables the NFS client.
Enables the remote PowerShell.
Adds the WinRM rule to firewall.
Enables the WinRM client and server authentication.
Click
Close.
The downloaded configuration management packs are now displayed in the
Installed Management Packs list.
NOTE Informational event (event ID 71) is generated in the Windows Event Viewer under
Windows Logs > Application. This event contains information about the prerequisites which get configured on the management servers.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\