OptiPlex 7060 Tower Service Manual

Installing power supply unit or PSU

1. To install the PSU:
   1. Insert the PSU into the PSU slot and slide it towards the back of the system until it clicks into place [1].
   2. Replace the three screws to secure the PSU to the computer [3].
      
   3. Connect the PSU cables to the connectors on the system board [1].
   4. Route the PSU cables through the retention clips [2,3,4,5,6].
      
2. Close the front panel door.
3. Install the:
   1. Front bezel
   2. Side cover
4. Follow the procedure in After working inside your computer.