Installing the right fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the right fan and provide a visual representation of the installation procedure.
Steps
- Slide the fan below the heat sink and align the screw hole on the fan with the screw hole on the palm-rest and keyboard assembly.
- Replace the screw (M2x4) that secures the fan to the system board.
- Connect the fan cable to the system board.
- Align the screw holes on the I/O-board shield with the screw holes on the fan and system board.
- Replace the two screws (M2x4) that secure the I/O-board shield to the fan and palm-rest and keyboard assembly.
Data is not available for the Topic