- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Wi-Fi power cycle
- Flea power release
- Recovering the operating system
- Backup media and recovery options
- BIOS recovery
- M-BIST
- LCD Built-in Self Test (BIST)
- Getting help and contacting Dell
Precision 5560 Service Manual
Removing the battery
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the
base cover.
NOTE:Disconnecting the battery cable, removing the battery, or draining the flea power clears the CMOS and resets the BIOS settings on your computer.
About this task
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
Steps
- Disconnect the battery cable from the system board, if it was not disconnected earlier.
- Remove the four (M2x4) and four (M2x3) screws that secure the battery to the palm-rest and keyboard assembly.
- Peel the tapes that secure the speaker cable to the battery.
- Lift the battery off the palm-rest and keyboard assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\