- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Wi-Fi power cycle
- Flea power release
- Recovering the operating system
- Backup media and recovery options
- BIOS recovery
- M-BIST
- LCD Built-in Self Test (BIST)
- Getting help and contacting Dell
Precision 5560 Service Manual
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
Steps
- Place the I/O board on the palm-rest and keyboard assembly.
- Align the screw hole on the USB Type-C port bracket with the screw hole on the system board.
- Connect the two (M2x4) screws that secure the USB Type-C port bracket to the system board.
NOTE:Ensure to connect IO marked side of the I/O-board cable to the I/O daughter board and the side marked MB to the system board.
- Connect the I/O-board cable to the connector on the system board and I/O board.
Next steps
- Install the right fan.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\