Installing the solid-state drive1
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
CAUTION:Solid-state drives are fragile. Exercise care when handling the solid-state drive.
About this task
The following image indicates the location of the solid-state drive1 and provides a visual representation of the installation procedure.
Steps
- Align the notch on the solid-state drive1 with the tab on the solid-state drive slot.
- Gently slide the solid-state drive1 into the solid-state drive slot.
- Slide the solid-state drive thermal bracket into the alignment post on the system board.
- Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
- Replace the screw (M2x2) that secures the solid-state drive thermal bracket and the solid-state drive1 to the system board.
Data is not available for the Topic