Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R440 Installation and Service Manual

PDF

Removing power interposer board

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

  3. Remove the air shroud

  4. Disconnect all the cables connected from the PIB to the system board.
    NOTE Ensure that you note the routing of the cables as you remove them from the system board.
  5. Remove the PSU.

Steps

  1. Using a Phillips #2 screwdriver, remove the two screws securing the Power Interposer Board (PIB) to the system.
  2. Lift the board and slide it out at an angle to disengage the guide pins on the board.
    Figure 1. Removing power interposer board
    This image shows removing power interposer board
  3. Lift the board away for the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\