- Notes, cautions, and warnings
- Dell EMC PowerEdge R440 system overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Inside the system
- Backplane cover
- Air shroud
- Cooling fans
- Intrusion switch
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a 2.5-inch drive from a 3.5-inch drive adapter
- Installing a 2.5-inch drive into a 3.5-inch drive adapter
- Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
- Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
- Removing a hard drive
- Installing a hard drive
- Removing the drive from the drive carrier
- Installing a drive into the drive carrier
- System memory
- Processors and heat sinks
- Internal PERC riser
- Expansion cards and expansion card risers
- M.2 SSD module
- Optional MicroSD or vFlash card
- Optional IDSDM or vFlash module
- LOM riser card
- Hard drive backplane
- Cable routing
- System battery
- Optional internal USB memory key
- Optical drive (optional)
- Power supply units
- Power interposer board
- Control panel
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics
- Getting help
- Documentation resources
Dell EMC PowerEdge R440 Installation and Service Manual
System board jumpers and connectors
| Item | Connector | Description |
|---|---|---|
| 1. | FAN6 | Cooling fan 6 connector |
| 2. | CPU1 | Processor socket 1 |
| 3. | CPU1_PWR_CONN(P2) | CPU1 power connector |
| 4. | J_INTRU | Intrusion switch connector |
| 5. | J_BP_SIG1 | Backplane signal connector 1 |
| 6. | LFT_CP_CONN | Left control panel connector |
| 7. | J_SATA_B1 | Internal SATA B connector |
| 8. | RGT_CP_CONN | Right panel connector |
| 9. | SYS_PWR_CONN(P1) | System power connector |
| 10. | J_PIB_SIG1 | Power interposer board signal connector 1 |
| 11. | J_PIB_SIG2 | Power interposer board signal connector 2 |
| 12. | J_ACE | Internal Dual SD Module |
| 13. | J_CP_USB2 | Front USB connector |
| 14. | J_SATA_A1 | Internal SATA A connector |
| 15. | J_SATA_C1 | Internal SATA C connector |
| 16. | PCIE_G3_X8(CPU1) | Internal PERC controller connector |
| 17. | J_REAR_BP_PWR1 | Rear backplane power connector |
| 18. | J_FRONT_VIDEO | VGA connector |
| 19. | INT_USB_3.0 | USB connector |
| 20. | NVRAM_CLR | Clear NVRAM |
| 21. | PWRD_EN | Reset BIOS password |
| 22. | SLOT5 | PCIe slot 5 |
| 23. | SLOT4 | PCIe slot 4 |
| 24. | SLOT3 | PCIe slot 3 |
| 25. | J_TPM_MODULE | TPM module connector |
| 26. | J_BP_SIG0 | Backplane signal connector |
| 27. | J_MEZZ_A1 | LOM riser card connector |
| 28. | BATTERY | Battery connector |
| 29. | PCIE_G3_X16(CPU1) | Riser 1 connector |
| 30. | A6, A5, A10, A4, A9, A7, A1, A8, A2, A3 | Memory module sockets |
| 31. | B3, B2, B1, B4, B5, B6 | Memory module sockets |
| 32. | CPU2 | Processor socket 2 |
| 33. | PCIE_A0 | NVMe connector |
| 34. | CPU2_PWR_CONN(P3) | CPU2 power connector |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\