Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R440 Installation and Service Manual

PDF

Removing the optional IDSDM or vFlash card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If you are replacing the IDSDM/vFlash card, remove the MicroSD cards.
    NOTE Temporarily label each MicroSD card with its corresponding slot number after removal.

Steps

  1. Locate the IDSDM/vFlash connector on the system board.
    To locate IDSDM/vFlash connector, see the System board jumpers and connectors section.
  2. Holding the pull tab, lift the IDSDM/vFlash card out of the system.
    Figure 1. Removing the optional IDSDM/vFlash card
    Removing the ACE card
    NOTE There are two dip switches on the IDSDM/vFlash card for write-protection.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\