Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

XPS 13 Service Manual

PDF

Procedure

  1. Slide the I/O board at an angle and then align the screw holes on the I/O board with the screw holes on the palm-rest assembly.
  2. Adhere the tape that secures the I/O board.
  3. Align the screw hole on the display cable with the screw hole on the I/O board.
  4. Replace the two screws (M1.6x3) that secure the I/O board to the palm-rest assembly.
  5. Slide the I/O-board cable into the I/O board and close the latch to secure the cable.
  6. Slide the fingerprint-reader cable (optional) into the I/O board and close the latch to secure the cable.
  7. Connect the media-card reader cable to the connector on the I/O board.
  8. Adhere the tape that secures the display cable to the I/O board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\