- Notes, cautions, and warnings
- Audience and scope
- Overview
- Pre-deployment requirements
- Validated components
- Hardware overview
- Dell EMC PowerEdge MX7000
- Dell EMC PowerEdge MX740c compute sled
- Dell EMC PowerEdge MX5016s storage sled
- Dell EMC PowerEdge MX9002m management module
- Dell EMC Networking MX9116n Fabric Switching Engine
- Dell EMC Networking MX7116n Fabric Expander Module
- Dell EMC Networking MX5108n Ethernet switch
- Dell EMC PowerEdge MX5000s SAS switch
- Physical layout
- Cloud Foundation and SDDC design considerations
- Networking requirements
- Manual switch configuration
- SmartFabric network configuration
- Map PowerEdge MX5016s storage sled drives
- Deploy ESXi to cluster nodes
- Cloud Builder OVA deployment
- Running Cloud Builder
- Post-install validation
Dell EMC VMware Cloud Foundation for PowerEdge MX7000 Deployment Guide
Dynamic Host Configuration Protocol
Cloud Foundation uses Dynamic Host Configuration Protocol (DHCP) to automatically configure each VM kernel port of an ESXi host that is used as a VTEP with an IPv4 address. One DHCP scope must be defined and made available for this purpose.
The DHCP scope that is defined must be large enough to accommodate all the initial and future servers that are used in the Cloud Foundation solution. Each host requires two IP addresses, one for each VTEP configured.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\