- Notes, cautions, and warnings
- Audience and scope
- Overview
- Pre-deployment requirements
- Validated components
- Hardware overview
- Dell EMC PowerEdge MX7000
- Dell EMC PowerEdge MX740c compute sled
- Dell EMC PowerEdge MX5016s storage sled
- Dell EMC PowerEdge MX9002m management module
- Dell EMC Networking MX9116n Fabric Switching Engine
- Dell EMC Networking MX7116n Fabric Expander Module
- Dell EMC Networking MX5108n Ethernet switch
- Dell EMC PowerEdge MX5000s SAS switch
- Physical layout
- Cloud Foundation and SDDC design considerations
- Networking requirements
- Manual switch configuration
- SmartFabric network configuration
- Map PowerEdge MX5016s storage sled drives
- Deploy ESXi to cluster nodes
- Cloud Builder OVA deployment
- Running Cloud Builder
- Post-install validation
Dell EMC VMware Cloud Foundation for PowerEdge MX7000 Deployment Guide
Simple Mail Transfer Protocol mail relay (optional)
Certain components of the SDDC, such as vCenter, Log Insight, and vRealize Automation, can send status messages to users by
email. To enable this functionality, a mail relay that does not require user authentication must be available through SMTP.
As a best practice, limit the relay function to the networks allocated for use by Cloud Foundation.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\