- Notes, cautions, and warnings
- Audience and scope
- Overview
- Pre-deployment requirements
- Validated components
- Hardware overview
- Dell EMC PowerEdge MX7000
- Dell EMC PowerEdge MX740c compute sled
- Dell EMC PowerEdge MX5016s storage sled
- Dell EMC PowerEdge MX9002m management module
- Dell EMC Networking MX9116n Fabric Switching Engine
- Dell EMC Networking MX7116n Fabric Expander Module
- Dell EMC Networking MX5108n Ethernet switch
- Dell EMC PowerEdge MX5000s SAS switch
- Physical layout
- Cloud Foundation and SDDC design considerations
- Networking requirements
- Manual switch configuration
- SmartFabric network configuration
- Map PowerEdge MX5016s storage sled drives
- Deploy ESXi to cluster nodes
- Cloud Builder OVA deployment
- Running Cloud Builder
- Post-install validation
Dell EMC VMware Cloud Foundation for PowerEdge MX7000 Deployment Guide
Option 5—two PowerEdge MX7000 enclosures using Fabric Switching Engine
- Two or more (up to a maximum of 10) Dell EMC PowerEdge MX7000 enclosures
- Four Dell EMC PowerEdge MX740c compute sleds
- Two Dell EMC Networking MX9116n Fabric Switching Engines
- Two Dell EMC Networking MX7116n Fabric Expansion Modules
- Four Dell EMC PowerEdge MX5000s SAS IO Modules (only if using the MX5016s storage sleds)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\