- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the solid-state drive/Intel Optane memory module and provides a visual representation of the installation procedure.
If you are installing a solid-state drive/Intel Optane memory module that is a different form factor from the original (2280 to 2230), then first remove the solid-state drive screw-mount bracket and rotate it 180 degrees before inserting it in the other solid-state drive screw-mount bracket slot.