- Notes, cautions, and warnings
- Safety instructions
- Removing and installing components
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Dell G3 3590 Service Manual
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system board and provides a visual representation of the installation procedure.
NOTE
The I/O board connector is located underneath the system board. Turn the system board over and connect the I/O board cable to the system board.
Steps
- Connect the I/O board cable to the system board.
- Turn the system board to the front and align and place the system board on the palm-rest and keyboard assembly.
- Connect the speaker cable to the system board.
- Open the latch and connect the keyboard cable to the system board.
- Open the latch and connect the battery cable to the system board.
- Open the latch and connect the power-button cable to the system board.
- Open the latch and connect the hard drive cable to the system board.
- Replace the two (M2x2) screws that secure the system board to the palm-rest and keyboard assembly.
Next steps
- Install the power-adapter port.
- Install the display assembly.
- Install the heat sink.
- Install the left fan.
- Install the right fan.
- Install the WLAN card.
- Install the solid-state drive/Intel Optane memory module.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\