Dell PowerEdge R620 Owner's Manual

Installing the control panel—10 hard drive system

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Route the control panel cable through the chassis and connect the control panel cable to the control panel.
Push the control panel into the chassis till it snaps into place.
Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures the control panel to the chassis.
Locate the connectors J_CP and J_FP_USB on the system board.
- NOTE: To locate the connectors on the system board, see System Board Connectors.
Connect the control panel cable to the connectors on the system board (J_CP and J_FP_USB) and the hard-drive expander card.
- NOTE: Ensure that the control panel cable inside the system is routed along the chassis wall and secured using the cable securing bracket.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
If applicable, install the front bezel.