Dell PowerEdge R620 Owner's Manual

Installing the hard-drive backplane

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Holding the blue tabs, align the slots on the hard-drive backplane with the tabs on the chassis.
Slide down the hard-drive backplane until the release tabs snaps into place.
Attach the SAS A cable to the SAS A connector on the hard-drive backplane and the SAS B cable to the SAS B connector.
Connect the power cable(s) to the hard-drive backplane.
Route the power/data cables along the chassis wall.
Install the hard drives in their original locations.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
If applicable, install the front bezel.