Dell PowerVault ME4 Series Storage System CLI Guide

Settings changed by restore defaults

This appendix summarizes the system settings that result from using the restore defaults command.

Table 1. Settings changed by restore defaults
Setting	Value
System information settings: System name System contact System location System information	Settings: Uninitialized Name Uninitialized Contact Uninitialized Location Uninitialized Info
Management protocols settings: CLI/Telnet CLI/SSH SLP FTP SFTP SNMP WBI/HTTP WBI/HTTPS SMI-S Unsecure SMI-S Debug In-band SES Activity Progress Reporting	Settings: Disabled Enabled Enabled Disabled Enabled Disabled Disabled Enabled Disabled Disabled Disabled Disabled Disabled
Management mode	v3
Users	(preserved)
CLI session timeout	30 minutes
Tasks and schedules	(preserved)
Management Controller debug logs	(preserved)
Storage Controller event logs	(preserved)
Time/date and NTP settings	(preserved)
Network IP settings	(preserved)
SNMP settings: SNMP trap notification level SNMP trap host IPs SNMP read community SNMP write community	Settings: none 0.0.0.0 public public
SMTP settings: Email notification Email notify filter Email addresses Email server Email domain Email sender Include logs	Settings: Disabled (none) (none) (none) (none) (none) Disabled
SSL/SSH certificates	(preserved)
License	(preserved)
Disk group metadata	(preserved)
Host port settings: FC link speed FC topology	Settings: Auto Point-to-point
Host names and profiles	(preserved)
Drive spin down	Disabled
Advanced settings: Disk group background scrub Disk group background scrub interval Partner firmware upgrade Utility priority SMART Dynamic spare configuration Enclosure polling rate Host control of caching Sync cache mode Independent Cache mode Missing LUN response Controller failure Supercap failure CompactFlash failure Power supply failure Fan failure Temperature exceeded Partner notify Auto write back Inactive drive spin down Inactive drive spin down delay Disk background scrub Managed logs Single controller mode Auto stall recovery Restart on CAPI fail Large pools	Settings: Enabled 24 hours Enabled Low Enabled Disabled 5 seconds Disabled Immediate Disabled Illegal request Disabled Enabled Enabled Disabled Disabled Disabled Disabled Enabled Disabled 15 minutes Disabled Disabled Disabled (for a dual-controller system) Enabled Enabled Disabled
FDE settings	(preserved)
Peer connections	(preserved)
Replication sets	(preserved)
Enclosure settings: Name Location Rack number Rack position	Settings: (cleared) (cleared) 0 0
Host groups	(preserved)
iSCSI port settings: IP IP version Netmask Gateway Router (IPv6 only)	Settings: (preserved) (preserved) (preserved) (preserved) (preserved)
Other iSCSI settings: CHAP enabled iSNS Jumbo frames	Settings: (preserved) (preserved) (preserved)
CHAP records	(preserved)
Volume identifying information	(preserved)
Volume groups	(preserved)
Pool settings: Thresholds Overcommit Limits and policy Snapshot space thresholds	Settings: (preserved) (preserved) (preserved) (preserved)
Volume snapshot retention priority	(preserved)
Volume tier affinity	(preserved)
Volume cache settings	(preserved)
Expander fault isolation	(preserved)
Expander PHY settings	(preserved)
Device identification LED status	(preserved)
Debug log settings	Each parameter is reset to its default setting.

Welcome

Welcome to Dell

Dell PowerVault ME4 Series Storage System CLI Guide

Settings changed by restore defaults

Rate this content