Dell DR Series System Administrator Guide

1. In Contact Name, enter a system contact name.
2. In Relay Host, enter a hostname or IP address for the relay host.
3. In Email Address, enter an email address for the contact.
4. Select Notify me of [DR Series] appliance alerts to be notified about system appliance alerts.
5. Select Notify me of [DR Series] software updates to be notified about system software updates.
6. Select Notify me of [DR Series] daily container statistics to be notified about container statistics on a daily basis.
7. Select Don't show me this again to not display the Customer Registration and Notification page again.
8. Click Confirm to have the DR Series system accept your settings (or click Skip without configuring any settings) to proceed with initialization.

1. In Current Password, enter the current administrator password.
2. In New Password, enter the new administrator password.
3. In Retype New Password, enter the new administrator password again to confirm it.
4. Click Next to continue with the initial configuration process (or click Back to return to the previous page, or click Exit to close the Initial System Configuration Wizard). The Initial Configuration — Networking page is displayed.

1. In Hostname, enter a hostname that meets the hostname naming convention: A-Z, a-z, 0–9, the dash special character (-), within a maximum 19 character limit.
2. In IP Address, select the Static or DHCP mode of IP addressing, and if planning to use a Secondary DNS, enter an IP address for the secondary domain name system.
3. In Bonding, select the Mode choice from the drop-down list (ALB or 802.3ad). Dell recommends that you verify the system can accept your bonding selection type. The connection will be lost unless it is correctly configured. For more information, see Configuring Networking Settings .
4. In Bonding, enter the MTU value for the maximum transmission unit (the MTU accepts values between 512 and 9000). For more information, see Configuring Networking Settings .
5. In Active Directory, enter a fully qualified domain name for the Active Directory Services (ADS) domain in Domain Name (FQDN), enter an organization name in Org Unit, enter a valid ADS username in Username, and enter a valid ADS password in Password. For more information, see Configuring Active Directory Settings .
   • NOTE: If an ADS domain has already been configured, you will not be allowed to change the values for the Hostname or IP Address settings.
6. Click Next to continue with the initial configuration process (or click Back to return to the previous page, or click Exit to close the Initial System Configuration Wizard). The Initial Configuration — Date and Time page is displayed.
   • NOTE: If the Microsoft Active Directory Services (ADS) domain has already been configured, the Initial Configuration — Date and Time page will not display.

1. If you select NTP, accept or revise the NTP servers as desired (you are limited to only three NTP servers), and in Time Zone, select the desired time zone from the drop-down list.
2. If you select Manual, in Time Zone, select the desired time zone from the drop-down list, click the Calendar icon and select the desired day in the month, and adjust the Hour and Minute sliders to the desired time (or click Now to choose the current date and time), and click Done.
3. Click Next to continue with the initial configuration process (or click Back to return to the previous page, or click Exit to close the Initial System Configuration Wizard)

• Navigation panel
• System Status bar
• System Information pane
• Command bar

Your login username is displayed at the top of the page. If you are logged in as a domain user, the domain is displayed in the format of domain\username. (You can only log in as a domain user after configuring Login Groups under Active Directory. This is a requirement for using Global View.)