- Notes, cautions, and warnings
- Introduction
- Preinstallation setup
- Install iDRAC Service Module
- Initial installation of iDRAC Service Module through iDRAC Enterprise or Datacenter or iDRAC Express on Microsoft Windows and Linux
- Install iDRAC Service Module on Microsoft Windows operating systems
- Silent installation of iDRAC Service Module on Microsoft Windows operating systems
- Modify iDRAC Service Module components on Microsoft Windows operating systems
- Repair iDRAC Service Module running on Microsoft Windows operating systems
- Uninstall iDRAC Service Module running on Microsoft Windows operating systems
- Install iDRAC Service Module on VMware ESXi
- Preinstallation requirements for VMware ESXi
- Install iDRAC Service Module on VMware ESXi using CLI
- Install iDRAC Service Module using the vSphere CLI
- Install iDRAC Service Module using vSphere Lifecycle Manager in vSphere Client
- Install iDRAC Service Module using Power CLI
- Uninstall iDRAC Service Module on VMware ESXi
- Install iDRAC Service Module on Linux operating systems
- Install iDRAC Service Module when System Configuration Lockdown mode is enabled in iDRAC
- Install iDRAC Service Module in container environment
- Configure iDRAC Service Module
- Security configurations and compatibility
- Features
- S.M.A.R.T monitoring
- Operating system information
- Lifecycle Controller log replication into operating system
- Automatic system recovery
- Windows Management Instrumentation Providers
- Prepare to remove a NVMe PCIe SSD device
- Remote iDRAC hard reset
- iDRAC access via Host OS
- Accessing iDRAC via GUI, WS-Man, Redfish, and Remote RACADM
- Enable-iDRACAccessHostRoute
- In-Band support for iDRAC SNMP alerts
- Mapping iDRAC Lifecycle Logs to OMSA and OMSS SNMP alerts
- Enable WS-Man remotely
- Autoupdating iSM
- FullPowerCycle
- SupportAssist on the box
- Configure the In-Band SNMP Get feature—Linux
- Configure the In-Band SNMP Get feature—Windows
- iDRAC GUI Launcher
- Single sign-on to iDRAC UI from host operating system administrators desktop
- IPv6 communication between iSM and iDRAC over OS to iDRAC Pass-through
- Isolation of OS to iDRAC Pass-through Independent feature
- Software RAID
- Metric Injection (Host OS Telemetry)
- Linux and Ubuntu installer packages
- Frequently asked questions
- Resources and support
- Contact Dell Technologies
Dell iDRAC Service Module 5.4.0.0 User’s Guide
Introduction
The iDRAC Service Module (iSM) is a lightweight software service that better integrates operating system features with iDRAC and can be installed on Dell PowerEdge 14th generation or later generation of PowerEdge servers. The iSM complements iDRAC interfaces—the user interface (UI), RACADM CLI, Redfish, and Web Services-Management (WS-Man)—with additional monitoring data. You can configure the iSM features from within the supported operating system depending on the features you install, and the unique integration needs of your environment.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\