OptiPlex 5090 Micro Form Factor Cable Cover Install Guide
Before you begin
Steps
- Save and close all open files and exit all open applications.
- Shut down your system: Click
.
NOTE If you are using a Linux operating system, see the documentation of your operating system for shut-down instructions.
- Disconnect your system and all attached devices from their electrical outlets.
- Disconnect all attached network devices and peripherals, such as keyboard, mouse, and monitor from your system.
CAUTION To disconnect a network cable, first unplug the cable from your system and then unplug the cable from the network device.
- If the system unit or the adapter is being installed on the monitor:
- Disconnect the power and all the display cables from the monitor.
- Remove the stand from the monitor and place the monitor on a clean and soft surface.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\