- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Removing the cover
- Installing the cover
- Removing the hard drive assembly
- Removing the hard drive from the hard drive bracket
- Installing the hard drive into the hard drive bracket
- Installing the hard drive assembly
- Removing the VGA board
- Installing the VGA board
- Removing the system fan
- Installing the system fan
- Removing the memory module
- Installing the memory module
- Removing the heat sink
- Installing the heat sink
- Removing the processor
- Installing the processor
- Removing the speaker
- Installing the speaker
- Removing the coin cell battery
- Installing the coin cell battery
- Removing the system board
- Installing the system board
- System board layout
- List of compatible monitor models
- Troubleshooting your computer
- System Setup
- Specifications
- Contacting Dell
OptiPlex 7040M Owner's Manual
Installing the heat sink
- Place the heat sink on the processor.
- Tighten the captive screws to secure the heat sink to the system board.
- Install the:
- Follow the procedure in After Working Inside Your Computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\