Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge M420 Systems Owner's Manual

PDF

Installing The Management Riser Card

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Install the management riser card on the blade system board:
    1. Lower the management riser card into place until the card connector fits into the corresponding connector on the blade system board.
    2. Secure the management riser card to the blade system board with the three screws.
  2. Install the blade system board.
  3. Replace the mezzanine card.
  4. Reinstall the SSD backplane.
  5. Replace the SSD(s). If there are two SSDs, be sure to reinstall them in their original locations.
  6. Install the SD card and the vFlash card.
  7. Install the blade in the sleeve.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\