CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
Remove the blade from the sleeve.
CAUTION: To prevent damage to the SSDs and the backplane, you must remove
the SSDs from the blade before removing the SSD backplane.
CAUTION: You
must note the number of each SSD and temporarily label them before
removal so that you can replace them in the same locations.
Remove the SSD(s).
Slide the blue release latches up.
Slide the SSD backplane away from the card-edge connector
on the management riser card and lift the SSD backplane out of the
blade.
Figure 1. Removing and
Installing the SSD Backplane
SSD backplane
SSD backplane connector
card-edge connector (on management riser card)
release latches (2)
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\