Options to set up
iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from
iDRAC . You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings utility
See
iDRAC User's Guide available at
https://www.dell.com/idracmanuals
Dell Deployment Toolkit
See
OpenManage Deployment Toolkit User's Guide available at
https://www.dell.com/openmanagemanuals
Dell Lifecycle Controller
See
Lifecycle Controller User's Guide available at
https://www.dell.com/idracmanuals
Chassis or Server LCD panel
See the LCD panel section
You must use the default
iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for
iDRAC .
NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.
NOTE: Ensure that you change the default user name and password after setting up the
iDRAC IP address.