CAUTION Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
Keep the Phillips #2 screwdriver ready.
Steps
Align the locking tabs on the control panel
with the notches on the chassis and angle the control panel until
it snaps into place.
When properly seated, the control panel will
be flush with the front panel.
NOTE For an eight 2.5 inch
hard drive chassis, tighten the screw to secure the control panel
to the bottom of the chassis.
NOTE For a ten 2.5 inch
hard-drive chassis, slide the control panel into the chassis and secure
the module with the screw.
Figure 1. Installing the
control panel—four 3.5 inch hard-drives chassis
control panel
notches (6)
Figure 2. Installing the
control panel—eight 2.5 inch hard-drives/SSDs chassis
control panel
notches (4)
control panel module
LCD connector cable
Figure 3. Installing the
control panel—ten 2.5 inch hard-drives/SSDs chassis
screw
control panel release latch
cable securing clip
control panel cable connecting to the system board
J_FP_USB connector cable
control panel
Next steps
Follow the procedure listed in the After working inside your system
section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
