Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge R430 Owner's Manual

Installing the standard optical drive

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Align the two notches on the metal standoffs with the slots on the side of the optical drive.
  2. Slide the optical drive into the notches until it is seated firmly and the release latch snaps into place.
  3. Connect the power cable.
  4. Connect the data cable to the back of the drive and to the SATA connector on the system board.
    NOTE Route and secure the cables using the cable routing latch on the system chassis to prevent them from being pinched or crimped.
    Figure 1. Installing the standard optical drive
    This figure shows installing the standard optical drive.
    1. optical drive
    2. data cable
    3. power cable
    4. release latch
    5. metal standoff (4)
    6. notch on the metal standoff (2)

Next steps

Follow the procedure listed in the After working inside your system section.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\