SATADOM for Dell PowerEdge R630, R730, and R730xd systems

PDF

Installing and Removing SATADOM

The 64 GB Serial ATA Disk on Module (SATADOM) Single-level cell (SLC) is available for the PowerEdge R630/R730/R730xd systems as a factory installed, internal solid state boot drive.

  • NOTE: BIOS needs to be configured to ensure that the SATADOM is the first boot device.

This high-write endurance SATADOM has been validated for use in Software Defined Storage (SDS) solutions such as EMC ScaleIO.

This drive can be utilized for solutions that require a high-write endurance.

This drive is configured as a boot device on a dedicated controller that is separate from the main data drives.

  • NOTE: SATADOM is not recommended as a general purpose boot device.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\