Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell DL1000 Appliance Owner's Manual

PDF

Removing the system board

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
  2. If installed, remove the front bezel.
  3. Open the system.
  4. Remove the following:
    1. cooling shroud
      • WARNING: The memory modules are hot to the touch for some time after the system has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components.
    2. memory modules
    3. cooling fan cables
    4. PERC H310 card and PERC H310 card riser
      • WARNING: The heat sink is hot to touch for some time after the system has been powered down. Ensure that you do not touch the heat sink while removing the system board.
    5. heat sink and processor
  5. Disconnect all other cables from the system board.
    • CAUTION: Take care not to damage the system identification button while removing the system board from the chassis.
  6. Remove the screws on the system board and slide the system board toward the front of the system.
    • CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
  7. Hold the system board by its edges and lift the system board out of the chassis.
    • CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
    Figure 1. Removing and installing the system board The figure shows removing and installing the system board.
    1. cooling shroud guide screws (2)
    2. screws (8)
    3. system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\