Dell Wyse Management Suite Version 1.3.1 Administrator’s Guide

PDF

Configuring direct ICA connection settings

Use the Direct ICA Connection settings page to configure the ICA connections which can be accessed on the ThinOS 8.5 and later version devises.

Table 1. Configuring basic settingsBasic settings
Option	Description
Connection Name	Enter the name of the connection with a maximum of 38 characters.
User Name	Enter the user name for the application login.
Password	Enter the password for the application login. NOTE: The password is not encrypted. Dell recommends that you do not specify the password. You are prompted to enter the password when the connection is created.
Domain Name	Enter the domain name for Windows network with a maximum of 19 characters.
Auto Start	Select this option to restart the connection automatically.
Reconnect After Disconnect	Select this option to reconnect the connection automatically after the connection is disconnected.

Table 2. Configuring connection settingsConnection settings
Option	Description
Host or Application	From the drop-down list, select your preferred option.
Host Name or IP Address	Enter the host name or IP address of the connection.
Browser IP	Enter the list of IP addresses or DNS registered names.
Encryption	Select this option to set an encryption level. From the drop-down menu, select your preferred option.
Resolution	Select this option to set the resolution for your monitor. From the drop-down menu, select the appropriate resolution for your monitor. NOTE: If you select an unsupported resolution, the device ignores the setting.

Table 3. Configuring local resourcesAdvanced settings
Option	Description
Map Printers	Select this option to automatically connect the local printers when the session starts.
Map Serials	Select this option to automatically connect the local serials when the session starts.
Map SmartCards	Select this option to redirect the smartcards to the remote session.

Table 4. Configuring logon settingsAdvanced settings
Option	Description
Logon Mode	Select this option to select the log in mode.
Start Command Application	Enter the start command application.
Start Command Working Directory	Enter the start command working directory.

Table 5. Configuring session settingsAdvanced settings
Option	Description
Audio Quality	Select this option to set the audio quality.
Alternate address via firewall	Select this option to enable an alternate address through the firewall.
Session Reliability	Select this option to enable the ICA session reliability.
Optimize For Low Speed Link	Select the check box to optimize session settings for low link speed.
Font Smoothing	Select this option to enable font smoothing. Font smoothing is a method to obtain sharper fonts in low resolution screens.
Session Window Behavior	Select this option to define whether the remote connection should be launched in a full-screen mode. Select either Full Screen or Window mode based on your preference. NOTE: Zero launchpad mode only supports full screen sessions. Window mode starts on a single screen while the full screen session spans both monitors.