Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

iDRAC9 Version 5.10.30.00 Release Notes

PDF

OS deployment

Table 1. SCP OSD failure OS Deployment through Server Configuration Profile (SCP OSD) may fail while performing an unattended install for RHEL with kickstart file.
Description OS Deployment through Server Configuration Profile (SCP OSD) may fail while performing an unattended install for RHEL with kickstart file.
Workaround Perform the following steps:
  1. Reboot the server and select ISOIMG from BIOS boot order to boot to the attached ISO.
  2. In the GRUB boot menu, select Edit and append "inst.ks=hd:LABEL=OEMDRV:/ks.cfg". This change initiates the OS installation process using the kickstart file.
Systems Affected All systems supported by this release.
Tracking number 210426
Table 2. Getting an error SWC0018 during OS installation Modifying BIOS Boot Mode while installing operating system thorough Lifecycle Controller GUI, an error "SWC0018" is displayed.
Description Modifying BIOS Boot Mode while installing operating system thorough Lifecycle Controller GUI, an error "SWC0018" is displayed.
Workaround This message does not impact the installation, click OK to proceed.
Systems Affected All systems supported by this release.
Tracking number 143561
Table 3. Boot mode error during OS deployment While deploying OS using LC UI, if the current boot mode is set to UEFI and you change the boot mode to BIOS and click Finish on the last LC UI page, an error is displayed stating that the boot mode could not be set. The system reboots after you click OK. However, on next boot to LC UI, the boot mode is changed to BIOS and the boot device selected during OS deployment is discarded.
Description While deploying OS using LC UI, if the current boot mode is set to UEFI and you change the boot mode to BIOS and click Finish on the last LC UI page, an error is displayed stating that the boot mode could not be set. The system reboots after you click OK. However, on next boot to LC UI, the boot mode is changed to BIOS and the boot device selected during OS deployment is discarded.
Workaround Before deploying OS using LC UI, change the boot mode to BIOS from BIOS setup (F2 at POST).
Systems Affected All systems supported by this release.
Tracking number 98665

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\