Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R730 Owner's Manual

PDF

Installing an expansion card into the expansion card riser 1

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the expansion card riser.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: The expansion card riser 1 can be used only when both the processors are installed.

Steps

  1. Unpack the expansion card and prepare it for installation.
    For instructions, see the documentation accompanying the card.
  2. Press tab A and rotate the latch clockwise.
  3. Press tab B and rotate the latch down.
  4. Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
  5. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
  6. Close the latches of tab A and tab B.
    Figure 1. Installing an expansion card into the expansion card riser 1
    This figure shows installing an expansion card into the expansion card riser 1
    1. tab A
    2. expansion card riser 1 cage
    3. expansion card connector
    4. tab B
    5. latch
    6. expansion card

Next steps

  1. Install the expansion card riser.
  2. If applicable, connect any cables to the expansion card.
  3. Follow the procedure listed in the After working inside your system section.
  4. Install any device drivers required for the card as described in the documentation for the card.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"