Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R730 Owner's Manual

PDF

Removing an expansion card from the expansion card riser 1

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Disconnect any cables connected to the expansion card.
  4. Remove the expansion card riser.
NOTE: The expansion card riser 1 can be used only when both the processors are installed.

Steps

  1. Press tab A and rotate the latch clockwise.
  2. Press tab B and rotate the latch downward.
  3. Remove the expansion card from the expansion card riser 1.
  4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening, and then close the expansion card latch.
    NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
  5. Close the latches of tab A and tab B.
    Figure 1. Removing an expansion card from expansion card riser 1
    This figure shows removing an expansion card from expansion card riser 1.
    1. tab A
    2. expansion card riser 1 cage
    3. expansion card connector
    4. tab B
    5. latch
    6. expansion card

Next steps

  1. Install the expansion card.
  2. Install the expansion card riser.
  3. Follow the procedure listed in the After working inside your system section.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"