Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R730 Owner's Manual

PDF

Installing the integrated storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.
  4. Remove the expansion card riser 1.
  5. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the end of the integrated storage controller card with the controller card connector on the system board.
  2. Lower the connector side of the integrated storage controller card into the integrated storage controller card connector on the system board.
    NOTE: Ensure that the tabs on the system board align with the screw holes on the integrated storage controller card.
  3. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
  4. Tighten the screws to secure the integrated storage controller card cable with the integrated storage controller card connector on the system board.
    Figure 1. Installing the integrated storage controller card
    This image shows installing the integrated storage controller card.
    1. integrated storage controller cable
    2. integrated storage controller card
    3. integrated storage controller card connector on the system board
    4. integrated storage controller card holder

Next steps

  1. Install the expansion card riser 1.
  2. Install the cooling shroud.
  3. Follow the procedure listed in the After working inside your system section.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"